Where is the valet switch located on a Viper alarm?

Where is the valet switch located on a Viper alarm?

Mounted in the driver’s side kick panel. Mounted in the steering column plastic housing. Behind a fuse block door or access panel. Low in the center console in the back of a pocket.

What is alarm valet mode?

The valet mode on a car alarm allows someone else to drive your car without having access to the security system. Valet mode is typically employed when you’re having your car parked or serviced. It enables you to maintain possession of your security remote.

How do you program a valet remote start?

1) Open a door and make sure the dome light is on. 2) Turn the ignition on to the RUN position or you may also start car. 3) Within 15 seconds press and release the Valet/Program push button to select the channel you wish to program. For example, press and release once for channel 1 (arm/disarm channel).

What is the valet button on a remote starter?

Valet mode is a setting/feature your remote starter has, that allows you to disable the ability to remote start the vehicle. It is designed to be used when you take your vehicle in for service or if you are lending the vehicle out and wish to prohibit (ie turn off) the ability to remote start the vehicle.

What is the valet override button?

The valet button or switch permits the owner to temporarily bypass the alarm functionality of the system. To enter or exit valet mode, disarm the system with a working transmitter, your personalized manual override code, or using the procedure below which is to enter or exit valet mode. 1.

How do I put VTP in valet mode?

To activate or deactivate Valet Mode: Press . 3. Press (labeled VALET on the keypad). The light will stay solid red, the system has now entered Valet Mode.

How do I get my remote starter off valet mode?

Insert your vehicle’s key into the ignition and turn to the “ON/RUN” position. Do not crank the engine. Tap the function or F button on the side of the remote 3 times, then press the LOCK button. If you see/hear two parking light flashes/clicks, you have exited valet mode.

What is a valet switch?

The valet switch allows you to temporarily bypass all alarm functions, eliminating the need to hand your transmitter to parking attendants or garage mechanics. When the system is in valet mode, all alarm functions are bypassed, however the remote panic feature and remote door locks will remain operational.