Is a 1 HP sump pump too much?

There is no “correct” size. The horsepower requirement for a house is determined by the area of drainage connected to the sump, the depth to groundwater, the depth of the basement and many other factors. A 1/3 horsepower (hp) pump is satisfactory for most houses, but a 1/2 hp pump doesn’t cost that much more.

Why does my sump pump have two plugs?

If you look at the outlet where you sump pump is plugged in, you should see two separate plugs. One is for the float switch, the other is for the motor. If the pump doesn’t turn on immediately, your pump needs to be repaired or replaced. If the pump worked properly, reconnect the other plug and you’re done.

How far can a 1/2 HP sump pump push water?

A 1/2 HP sump pump can handle 7 to 10 feet vertical lift off the sump pump, a 90-degree elbow and a horizontal pipe running between 3 and 25 feet.

How many gallons of water does a sump pump discharge?

The average homeowner sump pump is between 1/3 and 1/2 horsepower. The average discharge rate is between 2500 to 3200 gallons per hour (gph) or 42 to 53 gallons per minute (gpm).

How far can a sump pump discharge?

1/3 HP Submersible Sump Pumps Typically, 1/3 HP pumps can handle 7′ – 10′ vertical lifts from the sump pit if they have one 90-degree elbow and a horizontal pipe run between 3 feet and 25 feet.

What size submersible pump do I need?

You will also need to determine the best pump size, depending on your water home needs. Pumps are rated in GPM (gallons per minute). A typical 3- to 4-bedroom home requires 8-12 GPM. When determining your home water needs, add one GPM for every water fixture in your home.

What is a piggyback plug?

THE PIGGYBACK PLUG or “switchplug” is a convenient way to switch power to timers, level alarms, or a footswitch. Simply plug the piggyback plug into the wall and then plug your device into the female end. Power will then be passed through one blade of the plug when switched to “closed”.