How do you reset the maintenance light on a 2004 Saturn Vue?

To reset the 2004 Saturn Vue oil light, please follow these instructions:

  1. Turn the ignition to run (one position before starting engine).
  2. Immediately after Step 1 press and release the gas pedal 3 times within 5 seconds.
  3. Turn the ignition off and then start the engine to verify the indicator has been reset.

How do you reset the service light on a Saturn Vue?

Reset oil service light Saturn Vue

  1. Turn the ignition key to RUN/ON with the engine off.
  2. After step one fully press and release the accelerator pedal three times within five seconds.
  3. If the Change Engine Oil service light is flashing, the warning light is reset.

What does the wrench and oil light mean Saturn Vue?

This is a signal that the oil needs changing. If that has been done, then the computer may not have been reset, after it was changed.

How do you reset the change oil light on a 2003 Saturn L200?

Reset oil service light Saturn L200

  1. Switch to ON/Run the ignition, do not start the vehicle.
  2. Fully push and release the gas pedal three times within five seconds.
  3. If the Change Engine Oil warning light is flashing, the system is reset.

How do you reset the oil light on a Saturn?

Press the reset/trip button located on the display face inside the Saturn Ion and Relay models until the oil life display is present. Press the trip/reset button down until you hear chimes and the oil life display resets to 100 percent.

How do you get my service engine soon light off?

The only way to keep the light off is to repair the problem that turned the light on before attempting to turn it off.

  1. Turn the ignition switch to the on position but do not start the car.
  2. Count seven seconds, depress the gas pedal and hold it down for 10 seconds or until the service engine soon light begins flashing.

How do you reset the service engine soon light on a 2003 Buick Century?

How to Reset the Service Engine Light on the 2003 Buick

  1. Open the driver’s side door on the 2003 Buick and locate the diagnostic link connector (DLC) underneath the dashboard.
  2. Plug the OBD II scanner/eraser into the DLC.
  3. Place the key of the Buick into the ignition and turn the key to the accessory power position.