How do you read a Jeep Wrangler engine code?
How do you read a Jeep Wrangler engine code?
How to Check An Engine Code
- Insert key into the ignition.
- Turn to “ON” position without starting the Jeep.
- Push the key in and turn it to “OFF” and then to “ON” three times, leaving it in the “ON” position.
What kind of engine does a 1997 Jeep Wrangler have?
Two engines were available: the 2.5 liter four-cylinder developed by AMC and generating 120 hp; and the 4.0 liter inline six-cylinder, also developed by AMC, and generating 181 (or more) horsepower. At launch, the four-cylinder was only available in the base SE model; the 4.0 was in Sport and Sahara.
How do you check the codes on a Jeep Wrangler TJ?
How to display the codes:
- Turn the ignition key On – Off – On – Off – On within 5 seconds.
- Count the number of times the check engine lamp on the dash flashes on and off. The number of flashes represents the trouble code. There is a slight pause between the flashes representing the first and second digits of the code.
How much horsepower does a 1997 Jeep Wrangler have?
120 to 181 hp
1997 Jeep Wrangler/Horsepower
How heavy is a Jeep 4.0 engine?
AMC straight-6 engine
| Straight-6 engine | |
|---|---|
| Power output | 129–200 hp (96–149 kW; 131–203 PS) |
| Torque output | 216–280 lb⋅ft (293–380 N⋅m) |
| Dimensions | |
| Dry weight | 483 lb (219 kg) (4.0 L engine) |
How do you reset the check engine light on a 1997 Jeep Wrangler?
Resetting the Check Engine Light:
- Make sure the engine is not running and key is out of the ignition.
- Disconnect the battery terminals.
- Wait 5 minutes.
- Reconnect battery terminals.
- Insert and turn the ignition key to the run position without starting.
- All error codes are cleared and CHECK ENGINE icon disappeared.
How do I get obd1 codes?
The diagnostic connector is located under the dash panel by the driver side. To get the check engine codes to flash in your dash panel, use a jumper wire or a paper clip and connect terminals A and B of the diagnostic connector. Turn your ignition key on with engine off and the codes should start to blink.
How do I find out what my engine code is?
Find it in the lower corner of your windshield on the driver’s side. Your VIN number is your vehicle identification number and you can find your engine size by VIN number. In the series of numbers and letters, the tenth from the left denotes the model year and the eighth is the engine codes.
