How do I reset my Cisco wap121 router?

To restore the device to the factory default settings, with the power on, press-and-hold the Reset button with a bent paperclip for more than 10 seconds.

How to Configure cisco WAP 321?

Tutorial – Cisco WAP321 Initial Configuration

1. On the Web interface, access the Wireless menu and select the Wireless networks option.
2. Change the name of your wireless network. Select the type of network security: WPA Personal.
3. Configure the wireless password and save your configuration.

How do I find my Cisco WAP IP address?

To find the Access Point’s IP address

1. Open utility window, make sure Get IP addr is selected in the Function box.
2. Type the Access Point’s MAC address in the Device MAC ID field.
3. Click Get IP Address.
4. Write down the Access Point’s IP address that appears in the IP Address field.

What is single point setup?

Single Point Setup creates a dynamic, configuration-aware cluster, or group, of WAP devices in the same subnet of a network. Single Point Setup allows the management of more than one cluster in the same subnet or network; however, they are managed as single independent entities.

How do I reset my Cisco AP to factory settings?

Reset Cisco Wireless AP to factory defaults

1. Connect the console cable.
2. Unplug the power or network cable if connected to a POE switch.
3. Press and hold the Mode button.
4. Plug the power back into the AP.
5. Wait until the output on the console says button is pressed.

How do I setup a router as an access point?

Simply connect the access point to one of the ports of your existing wired/wireless router then configure the access point’s wireless settings.

1. Open the access point’s web-based setup page by entering the default IP Address “192.168.
2. On the web-based setup page, click on Wireless.
3. Enter the Network Name (SSID).

How do I console an access point?

To create a console connection to the AP: 1. Connect a local console to the serial port on the AP. You can connect the AP’s serial port to a terminal or terminal server using an Ethernet cable, or connect the serial console port to a DB-9 adapter, then connect the adapter to a laptop using an RS-232 cable.

How do I setup a Cisco wireless access point?

Cisco Wireless Access Points – Cisco Workgroup Bridges: Cisco Unified Wireless Network Configuration Example

1. Enter the SSID name, VLAN ID, and the RADIO interface.
2. In the Client Authentication Settings area, check the Open Authentication check box.
3. Leave all other parameters with their default values.
4. Click Apply.

What is single point setup Cisco?

Single Point Setup creates a dynamic, configuration-aware cluster or group of the WAP devices in the same subnet of a network. A cluster supports only a group of the configured Cisco WAP150 devices or a group of the configured Cisco WAP361 devices.

How do I Reset my Cisco wireless access point?

Use the System Configuration Setup page to restart the access point.

1. Click “Warm” Restart System Now to perform a warm restart of the access point. A warm restart reboots the access point.
2. Click “Cold” Restart System Now to perform a cold restart of the access point.